Egg Buddy

Plastic Fillable Egg – reg. size
2.5” x 4” White Fun Foam
1” x 2” Pink Fun Foam
2 – 7mm Moving Eyes
½” White Pom Pom
12” of White Crochet Thread
9” of 1/8” satin ribbon for bow
1/8” Hole Puncher
Low Temp Glue Gun & Glue Sticks


Trace and cut out pieces from fun foam according to the patterns.

Glue bottom of egg to the feet so that egg is standing upright. Glue the ½” white pom pom to the back at the bottom for the tail. This will also help keep your bunny from falling over. Glue an arm on either side of the lower half of the egg, just below the opening. Make sure that you do not get glue onto the opening or you may not be able to open your egg.

Glue the pink inner ears to the ears. Glue ears to the top of the egg. Make a loopy bow with the ribbon and glue to the front base of the ears.

Glue the moving eyes below the ears, about the middle of the top half of the egg.

Make a loopy bow with the white crochet thread for the whiskers. Cut the loops apart and trim as desired. Glue the knotted middle below the eyes. Punch a nose from the pink fun foam with a 1/8” hole puncher. Glue nose on top of the knot.
Fill your Egg Buddy with treats and share with a friend!

Comments are closed.