Bat Box

Supplies
Accucut Die – “Candy Box”
1 sheet – 8 ½ x 11” Black Heavy Cardstock (body & iris eyes)
1 piece – 2×4” White Cardstock (eyes)
1 yard – 1/8” Black Satin Ribbon #300
¾” Circle Punch – Marvy Uchida #30028718
1” Circle Punch – Marvy Uchida #30028719

Other supplies:
Adhesive – either Glue stick, Liquid glue, Hot glue (low temp) or Double stick tape Paper Piercer or 1/8” Hole puncher (Big Bite)

Optional:
Stickles Glitter Glue:
Black Diamond #30014971
Red #30014973
Crystal #30014975

Directions
1. Body – Die cut “Candy Box” from black cardstock. Save all scrap pieces.
2. Eyes – Punch out two 1” circles from white cardstock and two ¾” circles from black cardstock. Then glue the black circles onto the white circles. Glue eyes on the center of Panel 4. (Optional – Add “Black Diamond” or “Crystal” glitter glue to black iris of eyes.)
3. Holes – Using the paper piercer or hole puncher, make two holes on Panel 3. Then tie the black ribbon though the two holes.
4. Glue Panel 1 on top of Panel 5, to close the box.
5. Fangs – Turn the circle punch upside down, so that you can see the white cardstock in the cut out circle. Then punch a “half moon” shape from the side of the existing circle. Cut the circle in half to create 2 fangs. Glue only tops of fangs onto edge of Panel 4, below the eyes. (Some of fangs need to be hanging off of box) (Optional – Add “Red” glitter glue to fangs)
6. Tie ribbon on one side of box on diamond cutouts.
7. Fill box with treats, then close other end.

Comments are closed.